Table of Contents
Advertisement
78K0R - Cool it!
7. Hardware installation
After unpacking 78K0R - Cool it!, connect the board to your host computer using the provided USB interface
cable. When 78K0R - Cool it! is connected, the USB driver needs to be installed on the host machine.
Please refer to the following CHAPTER 8 SOFTWARE INSTALLATION.
8. Software installation
The 78K0R - Cool it! package comes with the following software demo packages:
•
IAR Systems Embedded Workbench for 78K0/78K0S/78K0R, including C compiler, assembler, linker,
librarian and IAR C-SPY debugger / simulator
•
Sample programs
The IAR Systems Embedded Workbench must be installed on your PC. For detailed installation hints, refer
to the following chapters and to the corresponding documentation of the IAR Embedded Workbench.
8.1 IAR Systems Embedded Workbench for 78K0/78K0S/78K0R installation
To install the IAR Systems Embedded Workbench for 78K0/K0S/K0R including C-SPY debugger / simulator,
select the SETUP program in the directory \IAR Embedded Workbench 78K\ew78k\ of the CDROM.
The setup dialogues will guide you through the installation process.
8.2 Sample program installation
To install the sample/demonstration program for the 78K0R – Cool it! board select the SETUP program in the
directory \SamplePrograms\ of the CDROM. The setup dialogues will guide you through the installation
process.
User's Manual U18426EE1V0UM00
27
Advertisement
Table of Contents
