Page 2
Installing the Kit Remove the shoulder screw and washer securing the top of the damper (Figure Remove the 3 shoulder screws from each pod While holding the damper stud in place using a and remove the pods from both sides of the wrench, remove the locknut (1/4 inch) securing machine (Figure...
Page 3
Install each pod using the previously removed 3 shoulder screws from each side (Figure Install the previously removed fuel-tank cap on the left pod (Figure g253591 Figure 5 1. Shoulder screw 3. Fuel-tank cap 2. Pod Repeat this procedure on the right side of the machine.