Toro 134-4194 Installation Instructions

Shredder Bar Kit
Model No. 134-4194—Serial No. 400000000 and Up
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
1
Preparing the Machine
No Parts Required
Procedure
1. Park the machine on a level surface.
2. Engage the parking brake.
3. Raise the cutting unit.
4. Shut off the machine and remove the key.
5. Support the cutting unit with jack stands.
© 2020—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Description
No parts required
No parts required
Shredder bar
Carriage bolt (10 X 25 mm)
Flange locknut (10 mm)
Register at www.Toro.com.
Qty.
–
Prepare the machine.
–
Prepare the deck.
1
8 Install the kit.
8
2
Preparing the Deck
No Parts Required
Procedure
1. Clean the top of the deck as shown in
2. Clean the bottom of the deck as shown in
Figure 2.
Original Instructions (EN) All Rights Reserved *3438-786* A
Printed in the USA
Form No. 3438-786 Rev A
Installation Instructions
Use
Figure
Figure 1
1.
g317984