Attaching/Detaching The Brush Attachment; Steam Brush Function - Silvercrest SDRB 1000 A1 Operating Instructions Manual

To extend the optimal steam blast function, mix mains
water with distilled water according to the table.
Water hardness
very soft / soft
medium
hard
very hard
The water hardness level can be queried at your
local water works.
Attention!
Before refilling with water, ALWAYS remove the
plug 7 from the mains power socket! There is a
risk of electric shock!
• Lift the water tank 1 up vertically, in that you slide
the release 4 for the water tank 1 to the rear until
the water tank 1 allows itself to be lifted off. Grasp
the water tank 1 with your thumb and index finger
on the hatched markings to lift it vertically upwards.
The temperature controller 3 remains on the appli-
ance and is not lifted off.
• Open the water fill opening 2 to the water tank 1.
• Using the measuring beaker t, fill the water
tank 1 with mains water to the "Max" marking,
but no further.
• Close the water fill opening 2 to the water tank 1.
Ensure that the lug on the water fill opening 2
sits in the indentation on the lid. Only in this way
is the water tank 1 properly closed.
• Replace the water tank 1 back onto the appliance.
The water tank 1 must audibly engage with the
unlocking device for the water tank 4.
Ratios - distilled
water to mains
water
0
1: 1
2: 1
3: 1
Attaching/detaching the brush
attachment
Attention!
NEVER attempt to attach or detach the brush attach-
ment w when the appliance is heated up. Risk of
Burns!
• To use the steam and brush function, place the
brush attachment w onto the steam brush.
• To do this, slide the brush attachment w all the
way along the guide to the end. The unlocking
device of the brush attachment q must engage
audibly.
• To be able to use the ironing function, remove
the brush attachment w from the steam brush.
• To do this, press the unlocking device q down-
wards and, at the same time, pull the brush attach-
ment w away to the front.

Steam brush function

• Place the brush attachment w onto the applian-
ce. This must engage audibly with the unlocking
device on the brush attachment q.
• Insert the power plug 7 into a correctly installed
and earthed mains power socket.
• To generate steam, set the temperature regulator
3 to at least ••• or higher. The heating-up con-
trol lamp 5 glows. As soon as the set temperature
has been reached, the heating-up control lamp
5 goes out.
Note:
For the steam blast function, set the temperature
regulator 3 to at least •••.
At lower settings the temperature is not sufficient to
generate a steam blast.
• By pressing the steam blast button 8 you can
now produce jets of steam.
- 7 -