1 Insert the rubber cap into the drain boss up to the extruded portions.
2 Insert the boss into the unit base and turn approximately 40 degree counterclockwise.
3 Size of the drain boss is
-
RAS-(4-10)WH(V)NP: 32 mm (O.D.)
-
RASM-(4-6)(V)NE: 32 mm (O.D.)
RASM-(2/3)VRE: 15 mm (O.D)
-
4 A drain pipe should be field-supplied.
?
N O T E
•
Do not use this drain boss set in a cold area, because the drain water may freeze.
•
This drain boss is not sufficient to collect all the drain water. If collecting drain water is completely required, provide a drain-pan that is bigger than
the unit base and install it under the unit with drainage.