Table of Contents
Advertisement
Panasonic Electric Works Nordic AB
MEW01228 Rev: 1
4.11.5.2
4.11.6
4.11.6.1
4.11.6.2
Operating Instructions Web512 V2.6.x for Web-server II 1598
Activate Alarm
When the outputs are disabled, a zone or an alarm point (zone –
address) can be set in alarm.
Type the Zone – Address and click Set to start the fire drill.
NOTE! The outputs type "Alarm device" will be activated, since they
are not disabled during the fire drill.
The fire alarm has to be reset, see chapter "Alarm", page 13.
Click Reset to reset the fire alarm.
When no more fire drills shall be performed, click ReEnable to re-
enable the outputs.
NOTE!
The disabled outputs can be listed, see chapter "Disablement", Device
type, page 17.
Click ReEnable to re-enable the outputs of the type respectively.
FTP / Telnet
Click FTP / Telnet to see the Service – FTP / Telnet view:
FTP Access
When a new site (incl. the Web-server II software) shall be
downloaded to the Web-server II, an FTP Access User name and
Password are always required.
To increase the safety, the FTP Access can be disabled as well. This
means that even if correct FTP User name and Password are used
there will be no FTP Access.
FTP Access has to be re-enabled before it is possible to use the FTP
Access User name and Password at all.
Click Disable to disable the FTP Access possibility.
Click ReEnable to re-enable the FTP Access possibility.
Telnet Access
A Telnet Access User name and Password are always required.
To increase the safety, the Telnet Access can be disabled as well.
This means that even if correct Telnet User name and Password are
used there will be no Telnet Access.
Telnet Access has to be re-enabled before it is possible to use the
Telnet Access User name and Password at all.
Click Disable to disable the Telnet Access possibility.
Click ReEnable to re-enable the Telnet Access possibility.
40
Advertisement
Table of Contents
