Table of Contents
Advertisement
2.3
Removing Emulation Probe from Target System
Remove the emulation probe from the target system by the following procedure.
<1> Switch off the power of the target system.
<2> Switch off the power of the IE-75001-R.
<3> Lift the shrink DIP socket lever.
<4> Pull out vertically the extractor at the end of the emulation probe, and remove the emulation probe
from the shrink DIP socket.
Shrink DIP Socket
12
CHAPTER 2 CONNECTIONS
Figure 2-7. 42-Pin Shrink DIP Emulation Probe Removal
Extractor
Target System
Lever
Advertisement
Table of Contents
