Proximity Flex Removal
NOTE
Remove the Proximity Grommet only if it is
defective or damaged. If the Proximity boot will be
reused, skip this step. After you remove the
Proximity grommet, you cannot reuse it.
1.
Use the Tweezers to remove the Proximity
sensor module from the front housing.
2.
Check the board for any remaining adhesive and
remove it with the pointed end of the plastic bar.
3.
Use the tweezers to remove the p-sensor flex
sponge.
4.
Remove the rubber of mic and main P Sensor
and sub PCB from the front housing.
PAGE 35
01/20/2015
Motorola Mobility Confidential Restricted:
Do not share without consent from Motorola