Pscd Gaps; Table 2. Pscd Gap Measurements - Lenovo motorola moto g Service Manual

PSCD Gaps

All dimensions are in millimeters (mm). The following gaps are considered maximum allowable without further approval.
Gaps measured with Pin Gauges must be done perpendicular to the surface/area being measured. Pin Gauges must not
be used at an angle as they will give false-positive results due to visual objectivity.

Table 2. PSCD Gap Measurements

No
1 The gap around the cover glass to the front housing
The step between front housing and cover glass at top and
2-1
bottom side
The step between front housing and cover glass at center
2-2
of left/right side
3-1 The step between front housing and speaker trim
3-2 The step between front housing and speaker trim
4-1 The gap around front housing and speaker trim
4-2 The gap around front housing and speaker trim
5 The gap around the rear cover and camera trim
6 The step between the rear cover and camera trim
7 The gap around the camera trim and camera lens
Concentricity between imager center eye to camera lens
8
artwork
9 The gap around rear cover and flash lens
10 The step between rear cover and flash lens
11 The step between front housing and rear cover
12 The gap between the front housing and volume key
13 The gap between the front housing and the power key
14 The gap between the rear cover and volume key
15 The gap between the rear cover and the power key
16 The gap between the front housing and the rear cover
17 The gap between the micro USB and rear cover
18 The gap between the front housing and the HSJ trim
19 The gap between the rear cover and the HSJ trim
20 Concentricity between imager center eye to lens artwork
21 Parallelism of screen and lens artwork in X
22 Parallelism of screen and lens artwork in Y
PAGE 9
Item
01/20/2015
Gap Spec
MAX: 0.3mm
Cover glass recess Min: 0.05mm
cover glass recess Min:0mm
Cover glass recess Min: 0.05mm
Cover glass recess Min: 0.05mm
MAX: 0.75mm
MAX: 0.75mm
MAX: 0.3mm
MAX:0.2mm
MAX: 0.2mm
MAX: 0.35mm
MAX: 0.3mm
MAX: 0.2mm
MAX: 0.25mm
MAX:0.3mm
MAX:0.3mm
MAX:0.3mm
MAX:0.3mm
MAX: 0.25mm
MAX:0.4mm
MAX:0.3mm
MAX:0.3mm
MAX: 0.35mm
|X1-X2|≤0.2mm
|Y1-Y2|≤0.2mm
Motorola Mobility Confidential Restricted:
Do not share without consent from Motorola