Replacing The Batteries - Silvercrest SNAW 1000 D2 Operating Instructions Manual

NOTE
► If "E" appears on the display 3 after entering a value, the value was
too high. The following maximum values can be entered:
► The appliance automatically calculates the values for kilojoules and
bread units from your entries.
The nutrition/energy value displays e now show all of the values, and the
food is now stored under the selected code.
10) Repeat steps 2) - 9) if you wish to enter more codes.
11) Enter the food in the appropriate field in the food tables of these operating
instructions.
NOTE
► You can also overwrite one of your previously saved codes by simply reas-
signing the code number and saving the new nutritional values under this
code.
► To stop saving your personal codes, press the ON/OFF button 9 to
switch off the appliance.

Replacing the batteries

If the appliance no longer works reliably, the display 3 becomes unreadable,
and/or "Lo" appears on the display, this means the batteries are exhausted and
need to be replaced with new batteries of the same type.
1) Open the battery compartment 2, remove the used batteries and dispose of
them in an environmentally friendly manner.
2) Insert two new 3 V CR2032 button cell batteries as per the polarity diagram
in the battery compartment 2.
3) Close the battery compartment 2. The battery compartment lid must click
into place.
■ 12 │ GB │ IE │ NI
PROT (protein)
FAT
CARB (carbohydrates)
KCAL (kilocalories)
CHOL (cholesterol)
500.00 g
500.00 g
500.0 g
5000
5000 mg
SNAW 1000 D2