Table of Contents
Advertisement
Image Installation Via PCMCIA ATA HARD DRIVE
Image Installation Procedure
• One of the following two bootable media:
– A bootable floppy and a USB floppy drive (an example is from Y-E DATA,
Inc.)
– A bootable ATA HARD DRIVE card
• A standard parallel crossover cable (male - male)
• Version 6.01 of the Ghost application - available from Symantec Corporation.
(This should be installed on the host PC and on the bootable media.)
• A copy of the PREGHOST utility. (This is available in the recovery CD or from
Motorola at FTP://MW520.MOT.COM). This should be installed on the
bootable media.
• A copy of the image to be downloaded onto the MW-520 unit. (This should be
on the host PC.)
ATA HARD DRIVE card Preparation Procedure:
1. Insert the ATA HARD DRIVE card into a computer with DOS 6.22 and type
the following command:
2. Edit the config.sys in the root of the ATA HARD DRIVE card so that it
contains the following strings:
device=a:\himem.sys
3. Edit the
autoexec.bat
contains the following strings:
@echo off
prompt $p$g
smartdrv.exe
4. Make sure that the following files are in the root directory of the ATA HARD
DRIVE card:
himem.sys
copied to the root directory of the ATA HARD DRIVE card from a PC with
MS DOS 6.22.
5. Copy the GHOST.EXE and the MW-520 system image (*.img or *.gho) files
to the ATA HARD DRIVE card.
1. Ensure that the MW-520 unit is turned off.
2. Insert the ATA HARD DRIVE card into the lower PCMCIA card slot of the
MW-520 unit.
The orientation of the PCMCIA slot on the MW-520 unit is upside down
from the orientation of previous versions of MW-520 units.
Note
3. Power-on the MW-520 unit and launch
prompt.
Loading a New System Image
format <PC drive letter> /s
in the root of the ATA HARD DRIVE card so that it
and
. If they are not, they must be
smartdrv.exe
GHOST.EXE
45
from the DOS command
Advertisement
Table of Contents
