Table of Contents
Advertisement
2.5
Hardware Installation
2.5.1
2.5" HDD Installation
For this process you will need a Phillips head screwdriver.
Step 1: Locate the removable 2.5" SATA Drive Bay on the front I/O side of the chassis.
Step 2: Unscrew the outer pins and remove the 2.5" SATA Drive Bay from the chassis.
Step 3: Unscrew the four (4) screws at each corner of the 2.5" SATA Drive Bay, and
insert the 2.5" HDD into the 2.5" SATA Drive Bay.
Step 4: Secure the HDD by reassembling the four (4) screws as shown.
Step 5: Reinsert the 2.5" SATA Drive Bay into the chassis, securing the outer pins once
inserted.
Chapter 2 – Hardware Information
38
Advertisement
Table of Contents
