Totalizers; Relays; Digital I/O Configuration; Analog Outputs - ABB C1300 Quick Start Manual

C 1 3 0 0/A DVA N C E D C I R C U L A R C H A R T R E C O R D E R | C I/C 1 3 0 0 - E N R E V. C

Totalizers

The totalizer configuration menu is used to configure the
totalizer settings for up to 4 totalizers. The following
parameters are available for configuration:
Totalizer 1(4) source
Totalizer 1 (4) tag
Totalizer 1 (4) count direction
Totalizer 1 (4) units
Totalizer 1 (4) Count rate
Totalizer 1 (4) cut off
Totalizer 1 (4) preset
Totalizer 1 (4) predetermined
Totalizer 1(4) wrap
Totalizer 1 (4) reset source
Totalizer 1 (4) run source
Totalizer 1 (4) log enable

Relays

The relay configuration menu is used to set up and assign
sources to all available relays within the product. The
parameters available to configure are:
Relay source
Relay Polarity

Digital I/O configuration

The digital I/O menu is only displayed when a digital input or
output type module is fitted. The parameters available to
configure are:
Digital Output source
Digital Output Polarity
Digital Input polarity

Analog outputs

The analog output configuration menu is used to set up and
assign sources to all available analog outputs within the
product. The parameters available to configure are:
Analog Output 1 (6) Source
Analog output 1 (6) range high
Analog output 1 (6) range low
Analog output 1 (6) electrical High
Analog output 1 (6) electrical Low

Logic equations

The logic equation configuration menu allows configuration of
up to 8 individual logic equations:
• System Clock
– Allows set up of the real time system clock
• Pen function
– Allows selection of Pen 1 to 4 function (trend or Event
marking)
• Calibration
– Allows span and offset adjustment of all inputs and
calibration of all pens.
13