Installation Area; Figure 6 Installation Area And Service Area; Figure 7 Installation And Service Areas (When A High-Density Drive Enclosure Is Installed_1) - Fujitsu ETERNUS DX100 S4 Site Planning Manual

1. ETERNUS DX Installation

Installation Area

Installation Area
This section explains the installation areas and the service areas that are required for an ETERNUS DX that is
installed in a Fujitsu 19-inch rack.
Secure service areas that are 850mm or more in the front and rear of the ETERNUS DX.
To install a high-density drive enclosure, secure a service area that is 1200mm or more in front of the ETERNUS
DX and a service area that is 850mm or more at the rear of the ETERNUS DX.

Figure 6 Installation Area and Service Area

Rear service area
ETERNUS DX
Front service area
Areas need to be secured temporarily around a rack to use a lifter to install a high-density drive enclosure in the
rack and perform maintenance work. When an area that is required to install a high-density drive enclosure can
be secured on the right side of the rack, refer to
drive enclosure can be secured in front of the rack, refer to

Figure 7 Installation and Service Areas (When a High-Density Drive Enclosure Is Installed_1)

Rear service area
ETERNUS DX
500mm or more
FUJITSU Storage ETERNUS DX100 S4/DX200 S4, ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems Site Planning Guide
850mm or more
850mm or more
850mm or more
Front service area
1800mm or more
Copyright 2021 FUJITSU LIMITED
Figure 7. When an area that is required to install a high-density
Figure 8.
1000mm
or more
26
P3AM-7632-18ENZ0