Australia, Class A - Siemens SIMATIC IFP1500 Operating Instructions Manual

The table below describes the test numbers of the HMI device classes:
Manufacturer site
Siemens AG
Industry Sector
Werner-von-Siemens-Straße 50
D-92209 Amberg, Germany
FCC and Canada
USA
Federal Communications
Commission
Radio Frequency
Interference Statement
Shielded Cables
Modifications
Conditions of Operations
CANADA
Canadian Notice
Avis Canadien
8.1.1

Australia, Class A

AUSTRALIA / NEW ZEALAND
This product meets the requirements of EN 61000-6-4:2007 Generic standards - Emission
standard for industrial environments.
This product meets the requirements of the standard EN 61000-6-4:2007 Generic standards
– Emission standard for industrial environments.
Industrial Flat Panel IFP1500, IFP1900, IFP2200
Operating Instructions, 09/2012, A5E31298376-AA
HMI device class
Comfort Panel, ITC, IFP
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely
to cause harmful interference in which case the user will be required to
correct the interference at his own expense.
Shielded cables must be used with this equipment to maintain compliance
with FCC regulations.
Changes or modifications not expressly approved by the manufacturer
could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-003
du Canada.
Technical information
8.1 Certificates and approvals
Test number
DEKRA11ATEX0005X
61