Sony Betacam SX DNW-A100 Maintenance Manual page 174

4-2. TAPE Maintenance Mode (M0)
4-2-6. OTHERS CHECK Mode (C4)
C40 : ROM VERSION
OTHERS CHECK MODE
C40:ROM VERSION
1
*
DNW-A100(UC)
SY1 V1.00 SY2 V1.00
2
SV1 V1.00 SSX V1.00
--- Option Boards ---
Component Input(AD-105)
3
This menu displays the model name of this unit, the
destination, the ROM version, and the information of the
installed option.
Description of superimpose picture
1 The model name of this unit and the destination in
parentheses are displayed on the superimpose picture.
The model name and destination are detected from the
setting condition of the DIP switch (S1102) on the SS-
63 board.
2 Each version number of system control ROMs (SY1
and SY2), a VTR servo ROM (SV1), and an SSX
board control ROM (SSX) is displayed on the super-
impose picture.
3 The installed options are displayed as described below.
BKDW-505/506 8
BKNW-103 8
BKNW-104 8
BKNW-105 8
m
. These options are automatically detected when they
are installed.
. The BKNW-103 option is used exclusively for
DNW-A100/A100P.
. BKDW-505/506 and BKNW-104 are options either
of which can be installed.
Menu operation
Turn the search dial to move the * mark.
The contents of an *-marked item on the superimpose
picture are displayed in a time data display area.
The installed option is displayed on only the superimpose
picture.
4-40
n
The display on the left is one
of the displayed examples.
Composite Input (DEC-65)
SDTI Input (CP-300)
Component Input (AD-105)
AES/EBU Input/Output
C41 : SERIAL NUMBER
OTHERS CHECK MODE
C41:SERIAL NUMBER
10001
This menu displays the serial number of this unit. When
each serial number does not coincide because of repair, it
can be set again in this menu.
m
. Set the serial number again after the MS-50 board or the
NV-RAM (IC9 on the MS-50 board) is replaced.
. "-----" is displayed in the state where no serial
number is set.
Serial number setting
(1) Turn the search dial to turn on and off the digit you
wish to set.
(2) Turn the search dial while pressing the JOG button and
change the digit number.
. Message "Push SET Button" is displayed on only
the superimpose picture when the serial number is
changed.
. To cancel the setting, press the MENU button to
terminate this menu.
(3) Repeat steps (1) and (2) for each digit.
(4) Press the SET button to save the set serial number.
. Message "Saving..." is displayed on only the
superimpose picture. If no abnormality is found, the
display changes to "Save Complete" after a few
seconds.
DNW-A100/A50/A45
DNW-A100P/A50P/A45P