Solving Problems With The Optional Auto Take-Up Reel; Uninstalling And Reinstalling The Printer Driver - Epson Stylus Pro 7880 User Manual

178 | Solving Problems
Solving Problems With the Optional Auto
Take-Up Reel
If you have problems using the optional Auto Take-Up Reel, try these
solutions:
Make sure you turned the printer off and then on again after installing
•
the Auto Take-Up Reel, and that the cable is securely connected to both
the printer and Auto Take-Up Reel.
Make sure there is enough slack in the roll paper as it feeds paper to
•
ensure that it interrupts the sensor so the Auto Take-Up Reel can turn.
See page 193 for details.
Make sure the
• Auto
the paper to be taken up. See page 198 for details.
Make sure you pressed the printer's l Paper Source button to select
•
(Auto Cut Off).
If the light flashes slowly when you are not printing, the sensor
• Sensor
may be misaligned or there may be an obstacle in the sensor's beam.
Make sure nothing is impeding the sensor's beam and adjust the sensor,
if necessary. See page 199 for instructions.
If the light is flashing rapidly, the Auto Take-Up Reel is locked.
• Sensor
Turn the printer off, then turn it on again to unlock it.
If the light is off, the Auto Take-Up Reel may be turned off or
• Sensor
the sensor cables may be disconnected. See page 199 to locate the
sensors and check to make sure the cables are connected securely.

Uninstalling and Reinstalling the Printer Driver

If you need to uninstall and then reinstall the printer driver software for any
reason, follow the instructions in the appropriate section below.
Macintosh
1. Open the
Applications
2. Double-click
Printer Setup Utility
.
Delete
178
switch is set for the direction in which you loaded
folder, then the
Utilities
, select your printer, and then click
folder.