Chapter 1:
Setting Up
the Printer
WARNING: Two people are
required to unpack and set
up the printer.
Note: When choosing a
place for the printer, leave
adequate room for easy
access and ventilation.
Avoid locations subject to
direct sunlight, excessive
heat, moisture, or dust.
Also avoid locations near
potential sources of
electromagnetic
interference, such as
loudspeakers, cordless
phones, TVs, or air
conditioners.
This chapter includes the following information:
Unpacking and assembling the Pro 7880 and Pro 9880
•
Connecting the power cord
•
Installing ink
•
Connecting to your computer and a network
•
Installing the printer software for Macintosh or Windows
•
Updating the printer firmware
•
Configuring the printer for a network
•
Unpacking and Assembling the
Epson Stylus Pro 7880
Follow these steps to assemble your printer and its stand. (If you have the
Epson Stylus Pro 9880, see page 29 instead.)
Before you begin, make sure you have sufficient space to set up and use the
printer. The following illustration shows the minimum space required for
using the Epson Stylus Pro 7880:
6 in.
(15.2 cm)
You will also need floor space of approximately 8 × 8 feet (2.4 × 2.4 m) to
assemble the printer and stand.
19
24 in.
(61 cm)
8 in.
(20.3 cm)
12 in.
(30 cm)
19