M]Reset [Poweron]; Ureset [0 | 1]; Memory Commands; Dump [Startaddr [Endaddr]] - Fujitsu F2MC-16L Series User Manual

3.4.5.

[M]RESET [POWERON]

Monitor Reset
This command is equivalent to pressing the Monitor Reset button. The parameter "poweron"
causes the monitor to proceed the Power On start-up. The monitor is completely re-initialised.
However, this effects only the monitor program. This does not cause a Power On for the
microcontroller device.
>reset↵
>reset poweron↵
... The first example resets the monitor. The second example completely re-initialises it.
3.4.6.

URESET [0 | 1]

User Program Reset
The monitor will initiate a hardware reset, so the user program will start at the address pointed
to by its reset vector.
and causes different memory mappings (see fig. 2, p 11).
>ureset↵
>ureset 1↵
... The first example keeps current User Mode and starts at the address stored at FFFFDCh.
The second example sets User Mode 1 before hardware reset.
NOTE: This command is similar to pressing the User Reset button. However, the User Mode
register (see fig. 4, p 12, board controls) is not preset to the SW3/3 value, but to the
mode parameter, if specified.

3.5. Memory Commands

DUMP [ S
3.5.1.
Dump memory area in byte format
The Dump command displays the memory contents of the specified address range.
If no EndAddress is specified, a memory area of 64 bytes is displayed.
If no StartAddress is specified the dump is continued at the following location of a previous
dump.
>dump↵
>dump a1000↵
>dump a1000 a1100↵
>dump,a1200↵
© FUJITSU Mikroelektronik GmbH 1996
FUJITSU MB90675-Evaluation Board - User Manual
The parameter indicates the User Mode (USER0/USER1) to be set
A
TART DDR
[ E A
]]
ND DDR
- 27 -