Bclear [Bnumber]; Bdisable [Bnumber]; Benable [Bnumber]; Symbols - Fujitsu F2MC-16L Series User Manual

3.6.2. BCLEAR [BN
Clear Breakpoint
If no BreakpointNumber is specified, this command will clear all breakpoints otherwise the
break point with BNumber is cleared.
>bclear↵
>bclear 1↵
3.6.3. BDISABLE [ BN
Disable Breakpoint
If no BreakpointNumber is specified, this command will disable all breakpoints. Their data are
still defined, but the breakpoint is not written into the user program RAM.
>bdisable↵
>bdisable 1↵
3.6.4. BENABLE
Enable Breakpoints
If no BreakpointNumber is specified, this command will enable all breakpoints. This command
also resets the breakpoint occur counter.
>benable↵
>benable 1↵
3.6.5.

SYMBOLS

Type Symbol information
This command will type all symbol names and values, if available.
The monitor can accept symbol names as command parameters and will display symbol names
within in the 'DISASSEMBLE' and 'TRACE' commands, if symbol information is available.
Symbol information can be included within the User Program (see example programs) or can
be separately downloaded into any free RAM area.
>symbols↵
NOTE: The default area of the symbol table starts at F92800h above the monitor data, if the
"MAP2SYM.EXE" program is used. Do not link any programs or data areas to this
region.
© FUJITSU Mikroelektronik GmbH 1996
FUJITSU MB90675-Evaluation Board - User Manual
UMBER
UMBER
BN
[
UMBER
]
]
]
- 35 -