Stop Gate Motor M3 & Sensor Q7 - Sharp MX-TMX1 Service Manual

AREA C
3.2.11 STOP GATE MOTOR M3 & SENSOR Q7
[D]
Removal
1. Remove Stop gate carriage (
2. Remove nut [A] (
3. Remove Crank arm [B].
4. Remove screws [C] holding the motor (
5. Loosen set screw [D] ( x1).
Replacement
1. Mount the Crank pulley [E] without tightening the set screw [D] ( x1).
2. Mount motor with screws [C] (
3. Mount Crank arm [B].
4. Tightening nut [A] (
NOTE: Make sure play for Crank arm [B] is maintained.
5. Position the Crank pulley [E] so it is aligned with Crank arm [B].
6. Tighten set screw [D] ( x1) on the flat of the shaft..
7. Reinstall Stop gate carriage (
[E]
3.2.10).
x1).
x4).
x1).
3.2.10).
TR-3-26
[B]
[A]
x4).
20 October 2010
[C]