Table of Contents
Advertisement
FAULT CODE DESCRIPTIONS
TM-018
Fault Code TM-018, indicates that the Trim bin full sensor (TM-Q8) is faulty.
Initial Actions
Make sure that the Trim bin full sensor (TM-Q8) is installed correctly.
Procedure
1. Replace sensor TM-Q8.
2. Disconnect plug B.P13 from PCB "A". Measure between J13-10 and J13-12 (5V and ground). The voltage is
approximately 5 VDC?
Y
N
Replace PCB "A".
Disconnect plug from sensor TM-Q8. Check wires for Continuity / Short circuit from, the white wire Q8 to
B.P13-11. Is there Continuity and no Short circuit?
Y
N
Replace wire Harness.
Connect plug B.P13 to PCB "A". Measure between the red wire Q8 and the black wire Q8 (5V and ground). The voltage is
approximately 5 VDC?
Y
N
Replace wire Harness.
Replace PCB "A".
TM-150 / 151
Fault Code TM-150, indicates that the Unreg is low/high.
Procedure
Measure between D.P14-1 and D.P14-2in the MX-BMX1. The voltage is approximately 36V?
Y
N
Replace the MX-BMX1 Interlock PCB "D".
Measure between D.P14-7 and D.P14-8 in the MX-BMX1. The voltage is approximately 36V?
Y
N
Replace the MX-BMX1 Interlock PCB "D".
Power OFF the Booklet Maker. Remove the power cable between the booklet maker and the trimmer. Measure for continuity
in the wires between Pin 1, 2, 7 and 8 on both ends of the cable. Is there continuity between all cables?
Y
N
Replace the power cable between the MX-BMX1 and MX-TMX1.
Power ON the Booklet Maker. Measure between A.J12-1 and A.J12-2 in the MX-TMX1. The voltage is approximately 36V?
Y
N
Replace the MX-TMX1 wire harness.
Replace PCB "A".
TR-4-10
20 October 2010
Advertisement
Table of Contents
