Problems With Image Size And Position; Print Quality Problems - Panasonic WORKIO DP-CL21 Maintenance And Specifications

Settings and Printing

! Problems with image size and position

Trouble
Off-set images.
Cut-off images.

! Print quality problems

Trouble
Prints have dull, faded
colors.
Maintenance and Spec.
Maintenance and Spec.
1. Check your application for correct image sizing.
If the trouble still remains, perform the following step.
2. Adjust the top or left margin
"Settings and Printing").
1. Check your application for image sizing.
If the trouble still remains, perform the following step.
2. Make sure that the correct size media is in the media tray.
If the trouble still remains, perform the following step.
3. Make sure that the image size is smaller than printable area (see
"Print Area" on page
If the trouble still remains, perform the following step.
4. Adjust the top or left margin
"Settings and Printing").
Print the Calibration Test Print Page from the Color Calibration menu in
the printer panel. Check the density settings for each color and compare
them with the color density samples on the Color Calibration Card. Refer
to "Adjusting the Color Density (Color Calibration)" on page 63
the "Settings and Printing" for instructions on comparing and setting
color density.
Make sure that the print cartridge stays covered until immediately before
installing it in the printer. Exposure to light can damage the print
cartridge and it will produce light streaks or faded prints.
Make sure that the toner cartridges are installed correctly.
Make sure that you use a high-quality laser paper:
2
60-105 g/m (16-28 lb.) paper in the media trays and
2
60-165 g/m (16-44 lb.) paper in the multi-purpose tray.
Network
Corrective Action
(see "Position Setting" on page 38
90).
(see "Position Setting" on page 38
Corrective Action
50
Troubleshooting
in
in
in