Corrective Action - Panasonic WORKIO DP-CL21 Maintenance And Specifications

Settings and Printing
Warning Message
TR Replace
FSR wearing out
FSR Replace
Tray1 Empty
Tray1 not installed
Tray2 Empty
Tray2 not installed
Tray3 Empty
Tray3 not installed
HDD Full
HDD I/O Error
Adjusting for media
Maintenance and Spec.
Maintenance and Spec.
Possible Cause
Transfer roller is worn out.
Fuser unit is wearing out.
Fuser unit is worn out.
Tray 1 is empty.
Tray 1 is not installed.
Tray 2 is empty.
Tray 2 is not installed.
Tray 3 is empty.
Tray 3 is not installed.
Hard disk drive is full.
HDD I/O error has occurred.
At continuous printing fuser
temperature is higher than
predetermined temperature.
Network
Warning / Printer Error Messages

Corrective Action

Replace the transfer roller.
Have the fuser unit available.
Replace the fuser unit.
Load media in the tray 1.
Install tray 1.
Load media in tray 2.
Install tray 2.
Load media in tray 3.
Install tray 3.
Remove unnecessary files from
the hard disk drive.
Perform Check Disk operation in
the HDD Maintenance mode.
If it still remains, perform Quick
Format or HDD Format operation
in the HDD Maintenance mode.
(see "Using the HDD
Maintenance Mode" on page 76
in "Settings and Printing).
The printing is stopped
automatically until the fuser
temperature is lower than the
predetermined temperature.
53