Panasonic KX-TD500 User Manual page 160

Station Features and Operation (PT/SLT)
Entering account codes during or after a conversation
During a conversation or within 15 seconds after the other party hangs up;
7230 / 7235 / 7433 / 7436
ACCNT
S2 S3
S1
Press ACCNT (S3).
You can keep talking
Conditions
Your Account Code Entry mode is set to one of the following three modes by System
Programming.
In "Verified - All Calls" mode
• You must always enter a system-registered account code to make a CO call.
• If the account code you entered is not found in the System Account Code Table
<Section 5.6 Account Code in the Programming Guide>, you hear a reorder tone.
• You can enter any account code during and after a call (after a CPC signal
detected).
In "Verified - Toll Restriction Override" mode
• You can override the Toll Restriction imposed on your extension by entering a
system-registered account code before making a CO call (Toll Restriction Override
by Account Code Entry).
• If the account code you entered is not found in the System Account Code Table
<Section 5.6 Account Code in the Programming Guide>, you hear a reorder tone.
In "Option" mode
• You can enter any account code when needed. It is possible to record a calling or
called party's account code in the SMDR, during a conversation or within 15 seconds
after the other party hangs up.
• You can enter any account code during and after a call (after a CPC signal
detected).
General
• To clear and re-enter the account code, press " ."
A Calling Party Control (CPC) signal is an on-hook indication sent from a CO line when the other end hangs up. You hear a
*1
reorder tone when the signal is detected.
160
account code
Enter account code Dial #.
(10 digits max., 0...9).
PT
(Account)
account code
Press Account Enter an account
(flexible button). (10 digits max., 0...9).
The corresponding
indicator light turns on.
You can keep talking.
Dial #.
is
*1
is
*1
User Manual