Polaris RZR XP 1000 Owner's Manual page 100

OPERATION
OPERATING GUIDELINES
STARTING THE ENGINE
Operating the vehicle immediately after starting could cause engine damage.
Allow the engine to warm up for several minutes before operating the vehicle.
1. Position the vehicle on a level surface outdoors or in a well- ventilated area.
2. Sit in the driver's seat and fasten the seat belt. Always make sure all cab
doors are closed and latched when riding in this vehicle.
3. Place the transmission in PARK.
4. Apply the brakes. Do not press the throttle pedal while starting the engine.
5. Turn the ignition key past the ON/RUN position and release immediately to
START. The engine will turn over for a maximum five seconds until the
vehicle has started.
6. If the engine does not start within five seconds, return the ignition switch to
the OFF position and wait five seconds. Repeat steps 5 and 6 until the
engine starts.
7. After starting the engine, wait 10 seconds before applying throttle.
BRAKING
1. Release the throttle pedal completely.
When the throttle pedal is released completely and engine speed slows to near
2. Press on the brake pedal evenly and firmly.
3. Practice starting and stopping (using the brakes) until you're familiar with the
controls.
98
NOTICE
idle, the vehicle has no engine braking.
TIP