Polaris RZR XP 1000 Owner's Manual page 58

FEATURES AND CONTROLS
To adjust the harness:
1. Put your arms through the shoulder belts. The belts should lay flat and not be
twisted. The shoulder belt should not rub against your neck or fall off your
shoulder.
2. Buckle the harness and check the fit of the lap
belt. It should be as short as possible and
pressed against your pelvic bones so that you
cannot lift yourself from the seat bottom at all.
Unbuckle and tighten the lap belts as needed
until the seat belt is properly adjusted – it is
easier to adjust the belts while unbuckled.
Finally, buckle the harness and listen for a click.
Check fit and make sure buckle is secure.
3. Tighten shoulder belts. If your harness is
equipped with non-retracting, adjustable
shoulder belts, tighten the shoulder belts until
they are snug across your chest when your
back is against the seat. When tightening the
shoulder belts, be sure to keep the harness
buckle centered and below your belly button.
The lap belt must remain pressed against your
pelvic bones.
4. Tighten thigh belts. If your harness is equipped
with thigh belts, adjust them for comfort and be
sure to keep the harness buckle centered and
below your belly button. The lap belt must
remain pressed against your pelvic bones.
5. Attach the chest clip between the shoulder
belts.
6. Put on your helmet.
56