Function - Panasonic YC-400TX Manual

7. Function

9
OUTPUT DISPLAY
ARC FORCE CUR
LOW
MID
OFF
PULSATION
PULSE CUR
16
1. Power switch
Controls input power supply.
*If the power switch trips out automatically, do not turn it back on .Contact manufacturer's agent.
2. Gas check switch
Set this switch at "Weld" when performing normal welding ,set it at "Check" when adjusting the flow of argon
gas.
3. Crater control switch
Crater "ON", "OFF" and "repeat" are controlled by this switch at TIG welding.
4. Power lamp
Turn on when the power switch is "ON".
5. Torch select switch
Cooling type, water cooling or AIR, is selected according to the torch in use.
6. Cooling water & Temperature warning lamp
Turns on when duty cycle is excessive or flow for the water cooled torch is insufficient. It is reset when a flow
8 7
INITIAL CUR
PULSE FREQ
PULSE WIDTH
10 11
17
6 5
TEMP
VOLT WATER POWER
AIR
WATER
SELECT
TORCH
DISPLAY
WELD CUR CRATER CUR
UP-SLOPE DOWN-SLOPE
12 13
18 19
11
4 3 2
ON
Once power switch trips auto-
matically, do not turn on again.
OFF
REPEAT
CRATER
CHECK
WELD
GAS
STICK
TIG
SPOT TIME
POST-FLOW
14 15
20 21
1
ON
OFF
POWER
SPOT
CONT
22 23