Toro Groundsmaster 4010-D Operator's Manual page 27

3. If the oil level is low, remove the plug at the 12 o'clock
position and add oil until it begins to flow out of the
hole at the 3 o'clock position.
4. Re-install both plugs.
Checking the Rear Axle Lubricant
Service Interval: Every 400 hours
The rear axle is filled with SAE 85W-140 gear lube. Check
the oil level before the engine is first started and every 400
hours thereafter. The capacity is 2.4 liters (80 oz.). Visually
inspect for leaks daily.
1. Position the machine on a level surface.
2. Remove a check plug from one end of the axle
15) and make sure that the lubricant is up to the bottom
of the hole. If the level is low, remove the fill plug
(Figure 15) and add enough lubricant to bring the level
up to the bottom of the check plug holes.
Figure 15
1. Check plug
Checking the Rear Axle Gear Box
Lubricant
Service Interval: Every 400 hours
The gear box is filled with SAE 85W-140 gear lube. Check
the oil level before the engine is first started and every 400
hours thereafter. The capacity is 0.5 liter (16 oz.). Visually
inspect for leaks daily.
1. Position the machine on a level surface.
2. Remove the check/fill plug from the left side of the
gear box (Figure 16) and make sure that lubricant is
up to the bottom of the hole. If the level is low, add
enough lubricant to bring the level up to the bottom
of the hole.
(Figure
g011487
2. Fill plug
1. Gear box
Checking the Tire Pressure
Service Interval: Before each use or daily
The tires are over-inflated for shipping. Therefore, release
some of the air to reduce the pressure. The correct air
pressure in the front and rear tires is 172-207 kPa (25-30 psi ).
Important: Maintain even pressure in all tires to
ensure a good quality-of-cut and proper machine
performance. Also, the Automatic Traction Assist
will not work properly with improper tire pressure.
Do not under-inflate. Replace worn or damaged tires
with genuine Toro tires that are correctly sized for this
machine.
Checking the Torque of the Wheel
Nuts or Bolts
Service Interval: After the first 10 hours
Every 200 hours
WARNING
Failure to maintain proper torque of the wheel nuts
could result in failure or loss of wheel and may
result in personal injury.
Torque the front wheel nuts and rear bolts to 115
to 136 N⋅ ⋅ ⋅ m (85 to 100 ft.-lb.) after 1-4 hours of
operation and again after 10 hours of operation.
Torque every 200 hours thereafter.
Adjusting the Height-of-Cut
Front Cutting Unit
The height-of-cut is adjustable from 25 to 127 mm (1 to
5 inches) in 13 mm (1/2 inch) increments. To adjust the
27
Figure 16
2. Check/fill plug
g011488