Servicing The Engine Oil And Filter - Toro Groundsmaster 4010-D Operator's Manual

Figure 49
1. Air cleaner primary filter
Figure 50
1. Air cleaner safety filter
Important: Never attempt to clean the safety filter
(Figure 50). Replace the safety filter with a new
one after every three primary filter services.
4. Replace the primary filter
5. Insert the new filter by applying pressure to the outer
rim of the element to seat it in the canister. Do not
apply pressure to the flexible center of the filter.
6. Clean the dirt ejection port located in the removable
cover. Remove the rubber outlet valve from the cover,
clean the cavity and replace the outlet valve.
7. Install the cover orienting the rubber outlet valve
(Figure 48) in a downward position - between
approximately 5:00 to 7:00 when viewed from the end.
Secure the latch.
g011504
g011505
(Figure 49).
Servicing the Engine Oil
and Filter
Service Interval: Every 250 hours
Change the oil and filter every 250 hours.
1. Remove the drain plug
into a drain pan. When all the oil is drained, install
the drain plug.
1. Engine oil drain plug
2. Remove the oil filter
clean oil to the new filter seal before screwing it on.
Do not overtighten.
1. Engine oil filter
3. Add oil to the crankcase; refer to Checking the Engine
Oil.
42
(Figure 51) and let the oil flow
Figure 51
(Figure 52). Apply a light coat of
Figure 52
g020434
g020436