Toro Groundsmaster 4010-D Operator's Manual page 30

Figure 25
1. Damper link
Figure 26
Adjusting the Skids
The skids should be mounted in the lower position when
operating at heights of cut greater than 64 mm (2-1/2 inches)
and in the higher position when operating at heights of cut
lower than 64 mm (2-1/2 inches).
Note: When the skids become worn, you can switch the skid
to the opposite sides of the mower, flipping them over. This
will allow you to use the skids longer before replacing them.
1. Loosen the screw at the front of each skid
g011549
2. Remove the flange-head bolts and nuts from each skid
(Figure
3. Move each skid to the desired position and secure them
with the flange-head bolts and nuts.
Note: Only use the top or center sets of holes to
adjust the skids. The bottom holes are used when
switching sides at which time they become the top
holes on the other side of the mower.
4. Torque the screw at the front of each skid to 9 to 11
N⋅m (80 to 100 in-lbs).
Adjusting the Cutting Unit Rollers
decal100-5694nc
The cutting unit rollers should be mounted in the lower
position when operating in height of cuts greater than 64 mm
(2-1/2 inches) and in the higher position when operating in
height of cuts lower than 64 mm (2-1/2 inches).
1. Remove the bolt and nut securing the gage wheel to
the cutting unit brackets
(Figure 27).
1. Gage wheel
2. Align the roller and spacer with the top holes in the
brackets and secure them with the bolt and nut.
30
Figure 27
27).
(Figure 28).
Figure 28
g008867
g011493