Maintenance; Recommended Maintenance Schedule(S) - Toro Groundsmaster 4010-D Operator's Manual

Maintenance

Note: Determine the left and right sides of the machine from the normal operating position.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 10 hours
After the first 200 hours
Before each use or daily
Every 50 hours
Every 100 hours
Every 200 hours
Every 250 hours
Every 400 hours
Every 800 hours
Every 1,000 hours
Every 2 years
Maintenance Procedure
• Torque the wheel lug nuts.
• Check the alternator belt tension.
• Check the compressor belt tension.
• Check the blade drive belt tension.
• Change the front planetary gear oil.
• Change the rear axle oil.
• Check the engine oil level.
• Check the coolant level.
• Check the hydraulic fluid level.
• Check the tire pressure.
• Check the air cleaner indicator
• Remove all debris and chaff from the engine compartment, radiator and oil cooler.
• Check the interlock switch operation
• Lubricate all grease fittings.
• Inspect the air cleaner.
• Check the blade drive belt tension.
• Clean the air conditioning screen. (Clean more frequently in extremely dusty or
dirty conditions)
• Inspect the cooling system hoses and clamps.
• Check the alternator belt tension.
• Check the compressor belt tension.
• Torque the wheel lug nuts.
• Change the engine oil and filter.
• Clean the cab air filters. (Replace them if they are torn or excessively dirty.)
• Clean the air conditioning coil. (Clean more frequently in extremely dusty or dirty
conditions)
• Check the planetary gear drive oil.
• Check the rear axle lubricant.
• Check the rear axle gear box lubricant.
• Service the air filter (if the indicator shows red).
• Inspect the fuel lines and connections.
• Replace the fuel filter canister.
• Drain and clean the fuel tank.
• Change the front planetary gear oil. (Or yearly, whichever comes first)
• Change the rear axle oil.
• Check the rear wheel toe-in.
• Inspect the blade drive belts.
• Change the hydraulic oil.
• Change the hydraulic oil filters.
• Inspect the side cutting unit damper.
• Inspect the cutting unit castor wheel assemblies.
• Check and adjust the valve clearance.
• Flush the cooling system and replace fluid.
• Replace moving hoses.
37