Page 1
Form No. 3436-227 Rev B Debris Kit STX-38 EFI Stump Grinder with Intelli-Sweep ® Model No. 140-3624 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. – No parts required Prepare the machine.
Preparing the Machine No Parts Required Procedure Park the machine on a level surface. Engage the parking brake. Raise the grinder and support it using jackstands. Shut off the engine and remove the key. g309583 Figure 1 Allow the engine to cool completely. 1.
Page 3
Drilling the Bracket Holes Parts needed for this procedure: Top bracket Bottom bracket Left bracket Hook and loop fasteners (from cylinder cover) Hook and loop fasteners (from hose cover) g323226 Figure 4 Hose cover Procedure 1. 15.6 cm (6-1/8 inches) 3.
Page 4
Note: Place the left bracket at the bottom of the welds Do not install the 15.6 cm (6-1/8 inch) of the wrap rod. Using the bracket as a template, fastener strip from the hose cover at this time. mark and drill holes (1/4 inch diameter) into the frame (Figure g323307...
Installing the Covers Parts needed for this procedure: Cylinder cover Hose cover g322789 Bolt (1/4 x 1 inch) Figure 11 Cylinder cover attached to frame fastener strips Nut (1/4 inch) Hydraulic cover Wrap the longer lengths of the cover between Procedure the hydraulic cylinder and grinder pivot and adhere them together...
Page 6
Secure the bottom of the cover using the bottom Clean the surface of the hydraulic cover where bracket, 2 bolts (3/8 inch x 1-1/4 inch), and 2 you are adhering the fastener strip (Figure 14). nuts (1/4 inch) as shown in Figure Remove the backing from the remaining hook and loop fastener strip and adhere it on the...
Page 7
Replacing the Guard Mount Parts needed for this procedure: Guard mount Clamp plate Bolt (5/16 x 1-1/4 inches) Locknut (5/16 inch) Procedure g309640 Figure 16 Remove the shield assembly from the grinder 1. Bolt—5/16 x 1-1/4 inches 4. Locknut—5/16 inch (12) head (Figure 15).
Page 8
g309637 Figure 18 1. Bolt—5/16 x 1-1/4 inches 4. Guard mount (12) 2. Clamp plate (2) 5. Locknut—5/16 inch (12) 3. Shield (2) Using the clamp plate and guard mount as a template, drill a hole (5/16 inch diameter) into both shields (Figure 19).