Advertisement
4
Installing the Covers
Parts needed for this procedure:
1
Cylinder cover
1
Hose cover
5
Bolt (1/4 x 1 inch)
5
Nut (1/4 inch)
1
Hydraulic cover
Procedure
1.
Install the hose cover around the hoses, with the
tapered end up
(Figure
Figure 10
1. Hose cover
2.
Align the holes on the bottom of the cover with
the holes in the frame. Adhere it to the hook and
loop fastener strip.
3.
Secure the cover using the left bracket, 2 bolts
(1/4 x 1 inch), and 2 nuts (1/4 inch) as shown
in
Figure
10.
4.
Secure the cover to the hoses using the cable
tie.
5.
Align the holes in the cylinder cover with the
holes in the frame and adhere it to the hook and
loop fastener strips
Note:
The tapered end of the cover extends
over the cylinder rod.
10).
2. Bolt (1/4 x 1 inch) and nut
(1/4 inch)
(Figure
11).
Cylinder cover attached to frame fastener strips
6.
Wrap the longer lengths of the cover between
the hydraulic cylinder and grinder pivot and
adhere them together
g323098
1. Longer length on cylinder cover
5
Figure 11
(Figure
12).
Figure 12
g322789
g322790
Advertisement
