Toro Groundsmaster 3300 Operator's Manual page 67

1. Move the traction pedal fully forward
Note:
The traction pedal should contact the
traction-pedal stop before the pump reaches
full stroke.
Figure 81
1. Traction pedal
2. Traction-pedal stop
2. If the traction pedal does not contact the
traction-pedal stop or if you want to reduce
the forward speed of the machine, perform the
following:
A. Hold the traction-pedal stop
a wrench.
B. Loosen the jam nut at the bottom of the
footrest plate
(Figure
3. Jam nut (top of the footrest
plate)
(Figure
(Figure 82).
81).
1. Jam nut (bottom of the footrest plate)
C. Move the traction pedal to the full forward
position
g320590
D. While holding the traction-pedal stop, adjust
the jam nut that is above the footrest plate
(Figure
contact with the stop.
E. Lengthen the traction-pedal stop position
by rotating the stop 1 full rotation
counterclockwise away from the jam nut
above the footrest plate.
Note:
position will increase the forward speed of
81) with
the machine.
F. While holding the traction-pedal stop, torque
the jam nut at the bottom of the footrest
plate
N∙m (27 to 33 ft-lb).
G. Check that the traction pedal contacts
the traction-pedal stop before the pump
reaches full stroke.
Note:
the traction-pedal stop, repeat steps
through G.
67
Figure 82
(Figure 81).
81) until the traction pedal makes
Shortening the traction-pedal-stop
(Figure 81 and Figure
If the traction pedal does not contact
g320591
82) to 37 to 45
A