Table of Contents
Advertisement
Figure 12
1. Expansion tank
3.
If the coolant is low, add a 50/50 mixture of
water and ethylene glycol anti-freeze. Do not
use water only or alcohol/methanol base
coolants.
4.
Install the radiator cap and expansion tank cap.
Filling the Fuel Tank
Fuel Tank Capacity
Fuel tank capacity: 79 L (21 US gallons)
Fuel Specification
Important:
Use only ultra-low sulphur diesel
fuel. Fuel with higher rates of sulfur degrades
the diesel oxidation catalyst (DOC), which causes
operational problems and shortens the service life
of engine components.
Failure to observe the following cautions may
damage the engine.
•
Never use kerosene or gasoline instead of diesel
fuel.
•
Never mix kerosene or used engine oil with the
diesel fuel.
•
Never keep fuel in containers with zinc plating on
the inside.
•
Do not use fuel additives.
Petroleum Diesel
Cetane rating: 45 or higher
Sulfur content: Ultra-low sulfur (<15 ppm)
Fuel Table
Diesel fuel specification
ASTM D975
No. 1-D S15
No. 2-D S15
EN 590
ISO 8217 DMX
JIS K2204 Grade No. 2
KSM-2610
g020441
•
Use only clean, fresh diesel fuel or biodiesel fuels.
•
Purchase fuel in quantities that can be used within
180 days to ensure fuel freshness.
Use summer-grade diesel fuel (No. 2-D) at
temperatures above -7°C (20°F) and winter-grade
fuel (No. 1-D or No. 1-D/2-D blend) below that
temperature.
Note:
Use of winter-grade fuel at lower temperatures
provides lower flash point and cold flow characteristics
which eases starting and reduces fuel filter plugging.
Using summer-grade fuel above -7°C (20°F)
contributes toward longer fuel pump life and increased
power compared to winter-grade fuel.
Biodiesel
This machine can also use a biodiesel blended fuel of
up to B20 (20% biodiesel, 80% petroleum diesel).
Sulfur content: Ultra-low sulfur (<15 ppm)
Biodiesel fuel specification: ASTM D6751 or
EN14214
Blended fuel specification: ASTM D975, EN590,
or JIS K2204
Important:
The petroleum diesel portion must
be ultra-low sulfur.
Observe the following precautions:
•
Biodiesel blends may damage painted surfaces.
•
Use B5 (biodiesel content of 5%) or lesser blends
in cold weather.
•
Monitor seals, hoses, gaskets in contact with fuel
as they may be degraded over time.
•
Fuel filter plugging may be expected for a time
after converting to biodiesel blends.
•
Contact your Authorized Toro Distributor if you
wish for more information on biodiesel.
26
Location
USA
European Union
International
Japan
Korea
Advertisement
Table of Contents
