Table of Contents
Advertisement
Checking the Planetary Gear Drive
Oil
Service Interval: Every 400 hours
Check the oil level after every 400 hours of operation
or if external leakage is noted. Use high quality SAE
85W-140 gear lube as a replacement.
1.
With machine on level surface, position the
wheel so one check plug
12 o'clock position and the other is at 3 o'clock
position.
Figure 15
1. Check/drain plug (2)
2.
Remove the plug at the 3 o'clock position
15). Oil level should be at the bottom of the
check plug hole.
3.
If the oil level is low, remove the plug at the 12
o'clock position and add oil until it begins to flow
out of the hole at the 3 o'clock position.
4.
Re-install both plugs.
Checking the Rear Axle Lubricant
Service Interval: Every 400 hours
The rear axle is filled with SAE 85W-140 gear lube.
Check the oil level before the engine is first started
and every 400 hours thereafter. The capacity is 2.4
liters (80 oz). Visually inspect for leaks daily.
1.
Position the machine on a level surface.
2.
Remove a check plug from one end of the axle
(Figure
16) and make sure that the lubricant is
up to the bottom of the hole. If the level is low,
remove the fill plug
lubricant to bring the level up to the bottom of
the check plug holes.
(Figure
15) is at the
(Figure
(Figure
16) and add enough
1. Check plug
Checking the Rear Axle Gear Box
Lubricant
Service Interval: Every 400 hours
The gear box is filled with SAE 85W-140 gear lube.
g019500
Check the oil level before the engine is first started
and every 400 hours thereafter. The capacity is 0.5
liter (16 oz). Visually inspect for leaks daily.
1.
Position the machine on a level surface.
2.
Remove the check/fill plug from the left side of
the gear box
lubricant is up to the bottom of the hole. If the
level is low, add enough lubricant to bring the
level up to the bottom of the hole.
1. Gear box
28
Figure 16
2. Fill plug
(Figure
17) and make sure that
Figure 17
2. Check/fill plug
g011487
g011488
Advertisement
Table of Contents
