Table of Contents
Advertisement
Specifications
Note:
Specifications and design are subject to
change without notice.
Width of cut
overall
front cutting unit
side cutting unit
front and one side cutting unit
Overall width
cutting units down
cutting units up (transports)
Overall length
Height
Height with ROPS
Height with cab
Ground clearance
Wheel tread (to center of tire)
front
rear
Wheel base
(Net Weight )
(Net Weight with cab)
Attachments/Accessories
A selection of Toro approved attachments and
accessories is available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
www.Toro.com for a list of all approved attachments
and accessories.
Operation
Note:
machine from the normal operating position.
335 cm (132 inches)
Before Operating
157 cm (62 inches)
107 cm (42 inches)
246 cm (97 inches)
If you leave the key in the ignition switch,
someone could accidently start the engine
and seriously injure you or other bystanders.
345 cm (136 inches)
183 cm (72 inches)
Remove the key from the ignition before you
do any maintenance.
342 cm (135 inches)
140 cm (55 inches)
Checking the Engine-Oil Level
217 cm (85.3 inches)
237 cm (93.3 inches)
Before you start the engine and use the machine,
check the oil level in the engine crankcase; refer to
17 cm (6-1/2 inches)
Checking the Engine-Oil Level (page
114 cm (45 inches)
Checking the Cooling System
119 cm (47 inches)
Service Interval: Before each use or daily
141 cm (55-1/2
Check level of coolant at the beginning of each
inches)
day. Capacity of system is 8.52 liters (9 qts) for the
1907 kg (4205 lbs)
Groundsmaster 4000 and 13.7 liters (14.5 qts) for the
2159 kg (4759 lbs)
Groundsmaster 4010.
25
Determine the left and right sides of the
CAUTION
1.
Carefully remove the radiator cap and expansion
tank cap
(Figure
12).
CAUTION
If the engine has been running, the
pressurized, hot coolant can escape and
cause burns.
• Do not open the radiator cap when the
engine is running.
• Use a rag when opening the radiator
cap, and open the cap slowly to allow
steam to escape.
2.
Check the coolant level in the radiator. The
radiator should be filled to the top of the filler
neck and the expansion tank filled to the Full
mark.
53).
Advertisement
Table of Contents
