HP E840 A Series User And Service Manual page 37

Rubber Door
Figure 2-12. Installing the Acrylic Door Hinges, Door Stops, and Latch Keeper.
Chapter 2
Stop
m3x
Pan
Head
Screws
Door
Latch
Rubber
Door
Stop
4. Slide the mainframe into the rack until the rack mount adapters
contact the rack's vertical rails.Start the dress screws but do not
tighten.
5. Install the door assembly by placing the hinges over the hinge pins on
the right adapter. Adjust the door for squareness and clearance by
holding the door in place while tightening the dress screws.
6. Adjust the latch keeper so that the door latches as it makes contact
with the rubber door stops.
Note
Once installed and adjusted, the door can be removed when necessary by
lifting the door off the hinge pins.
m5x10 Flat
Head Screws
m5x10 Flat
Head Screws
Rack Mounting and Option Installation
Hinge
Pins
37