Table of Contents
Advertisement
Replacing the
HP E8403A Power
Supply
Chapter 3
1. Turn off the mainframe and remove the power cord.
2. Remove the rear panel. Refer to "Removing the Rear Panel from the
Mainframe" on page 45 for instructions.
3. Using the rings on the power supply, gently pull the supply out from
the plastic connectors on the backplane adapter board. Do not carry
the supply using the rings.
Figure 3-5. Removing the HP E8403A Power Supply.
4. Install the exchange power supply. Keep the replacement power
supply to the far right in the mainframe. Make sure the supply is
firmly inserted into the backplane connectors.
5. Replace the rear panel. Make certain that all 14 screws are secured.
Servicing Your Mainframe 49
Advertisement
Table of Contents
