Replacement Power Cords - HP E840 A Series User And Service Manual

Replacement Power Cords

Table 3-3. Replacement Power Cords for the HP E8401 and E8403 VXI Mainframes
U.K.
Australia
Europe
U.S./Canada
U.S./Canada
Switzerland
Denmark
Japan
India / South
Africa
Chapter 3
6. Install the replacement impeller assembly by lining up the horizontal
slots on the bottom of the impeller assembly with the raised edges on
the mainframe. Slide the impeller assembly into the mainframe until
the impeller housing is over the screw locators.
7. Reconnect the impeller wires to the adapter board. Tighten the
impeller screws into the screw locators.
8. Replace the rear panel. Make certain that all 14 screws are secured.
Table 3-3 lists the power cords rated for use with the HP E840xA
mainframes. If it becomes necessary to replace the power cord, obtain the
appropriate cord listed in the table or use a cord with the same voltage and
current ratings.
Country Voltage
250 VAC
250 VAC
250 VAC
125 VAC
250 VAC
250 VAC
250 VAC
100 VAC
250 VAC
Power cords supplied by HP have polarities matched to the power input
socket on the instrument:
L = line or active conductor (also called "live" or "hot"
N = neutral or identified conductor
E = earth or safety ground
Part Number Part Number
for HP E8401 for HP E8403
8120-1351 8120-1351
8120-1369 8120-1369
8120-1689 8120-1689
8120-1378
8120-2371
8120-5338 8120-5338
8120-2104 8120-2104
8120-2956 8120-2956
8120-4753
8120-5400
8120-4211 8120-4211
Servicing Your Mainframe 51
Rated Amps
10A
10A
10A
10A HP E8401
13A HP E8403
10A
10A
10A
12A HP E8401
15A HP E8403
10A