Installation - Hitachi YUTAKI ATW-YCC-03 Installation And Operation Manual

3.1 Installation

!
CAUTION
• Transport the products as close as possible to the place to be installed before unpacking.
• Do not put any material on the product.
!
DANGER
• Install the device with enough clearance and space around it for operation and maintenance.
Install the YUTAKI CASCADE CONTROLLER where good ventilation is available
• Do not install the YUTAKI CASCADE CONTROLLER where there is a high level of oil mist, salty
air or sulphurous atmosphere.
• Install the unit as far as practical (being at least 3 meters) from electromagnetic wave
radiator (such as medical equipment).
• For cleaning, use noninflammable and nontoxic cleaning liquid. Use of inflammable agent
should cause explosion or fire.
• Work with sufficient ventilation. Working in an enclosed space should cause oxygen
deficiency. Toxic gas should be produced when cleaning agent is heated to high temperature
by, e.g., being exposed to fire.
• Cleaning liquid shall be collected after cleaning.
• Pay attention not to clamp cables when attaching the service cover to avoid electric shock or
fire.
!
CAUTION
• Install the device in the shade or not exposed to direct sunshine or direct radiation from high
temperature heat source.
• The device installation and connections must be performed by qualified professionals and
following the local directives.
• Check to ensure that the field supplied electrical components (mains power switches, circuit
breakers, wires, connectors and wire terminals) have been properly selected according to the
electrical data indicated on this document and they comply with national and local codes. If it is
necessary, contact with your local authority in regards to standards, rules, regulations, etc.
PMEN0581 rev.2 - 04/2023
3
12