Malfunction Causes And Remedies - Silvercrest SLB 450 A2 Operating Instructions Manual

Malfunction causes and remedies

GB
IE
Defect
Appliance does
not switch on.
Appliance does not
let itself be switched
off .
There are no air
bubbles exiting the
air-bubble mat.
Air-bubble mat does
not adhere to the
fl oor of the bathtub.
Appliance stops
automatically.
16
The following table will help with localising and eliminating minor malfunctions:
Possible cause
The plug is not inserted.
Mains power socket does
not supply any power.
The remote control
was not directed at the
appliance.
The battery in the remote
control is empty.
The battery in the remote
control is empty.
Function button
pressed often enough.
Appliance not switched on. Switch the appliance on.
Air hose
8
connected.
Suction cups of the air-
bubble mat are not clinging
fi rmly to the fl oor of the
bath.
Soap, shampoo or hair
remnants prevent fi rm
suction to the bottom of
the bath tub.
Cooling time after
operation too short.
NOTICE
► If you cannot solve the problem with the aforementioned methods, please
contact Customer Service.
Solution
Insert the plug into a mains power
socket.
Check the fuses.
9
On activation, aim the remote control
at the pump
Insert a new battery into the remote
control.
Insert a new battery into the remote
control.
Press the function button repeatedly
3 not
until the appliance switches off .
Properly connect/lock the air hose
not properly
to the air-bubble mat
pump .
Moisten the suction caps on the air-
bubble mat and then press it fi rmly
onto the bottom of the bath tub.
Remove the soap, shampoo or hair
remnants/rinse the bath tub out before
pressing the air-bubble mat down.
After use, allow the pump to cool
for at least 10 minutes and fi rst then
restart it if still needed.
Troubleshooting
.
and to the
6
SLB 450 A2