Table of Contents
Advertisement
Maintenance Service
Interval
After the first 100 hours
Before each use or daily
Every 50 hours
Every 100 hours
Every 200 hours
Every 250 hours
Every 300 hours
Every 400 hours
Every 500 hours
Every 1,000 hours
Note:
Download a free copy of the electrical schematic by visiting
machine from the Manuals link on the home page.
Important:
Refer to your engine owner's manual for additional maintenance procedures.
WARNING
Failure to properly maintain the machine could result in premature failure of machine systems,
causing possible harm to you or bystanders.
Keep the machine well maintained and in good working order as indicated in these instructions.
Maintenance Procedure
• Perform the guidelines for breaking in a new machine.
• Check the tire pressure.
• Check the engine-oil level.
• Check gear-shift operation.
• Check the brake-fluid level. Check the brake-fluid level before you start the machine.
• Check and clean around the muffler.
• Check and clean around the air intake.
• Under special operating conditions (refer to Maintaining the Machine under Special
Operating Conditions)—change the engine oil.
• Remove the air-cleaner cover and clean out the debris. Do not remove the
air-cleaner element.
• Clean out the debris in the dust cap.
• Under special operating conditions (refer to Maintaining the Machine under Special
Operating Conditions)—replace the air-cleaner element. Replace the air-cleaner
element sooner if dirty or damaged.
• Under normal operating conditions—change the engine oil.
• Check the spark plug.
• Check the condition of the tires and rims.
• Torque the wheel-lug nuts.
• Inspect the steering and suspension for loose or damaged components.
• Check the front wheel camber and toe-in.
• Check the operation of the neutral gear-shift position.
• Check the brakes.
• Under normal operating conditions—replace the air-cleaner element. Replace the
air-cleaner element sooner if dirty or damaged.
• Check the air filter for the carbon canister.
• Check the condition and tension of the drive belt.
• Check the tension of the starter-generator belt.
• Check the transaxle-fluid level.
• Grease the front wheel bearings.
• Replace the fuel filters.
• Clean the primary drive clutch.
• Replace the service and parking-brake pads.
• Check the fuel lines and connections.
• Change the transaxle fluid.
• Change the brake fluid.
www.Toro.com
24
and searching for your
Advertisement
Table of Contents
