Lifting The Machine; Lubrication; Greasing The Front Wheel Bearings - Toro Vista 08914 Operator's Manual

Lifting the Machine

DANGER
The machine may be unstable when using a jack. The machine could slip off the jack, injuring
anyone beneath it.
• Do not start the machine while the machine is on a jack.
• Always remove the key from the key switch before getting off the machine.
• Block the tires when the machine is supported by lifting equipment.
• Use jack stands to support the machine once you have lifted it.
Important:
Whenever you run the machine for routine maintenance and/or diagnostics, ensure
that the rear wheels of the machine are 25 mm (1 inch) off the ground, with the rear axle supported
on jack stands.
1. Front lifting point

Lubrication

Greasing the Front Wheel
Bearings
Service Interval: Every 300 hours
Grease specification: Mobilgrease XHP™-222
Removing the Hub and Rotor
1. Lift the front of the machine and support it with
jack stands.
2. Remove the wheel cover and the 4 lug nuts that
secure the wheel to the hub
Figure 19
(Figure 20).
29
2. Rear lifting point
g411857