Maintaining The Primary Drive Clutch; Reducing The Top Speed - Toro Vista 08914 Operator's Manual

Adjusting the Neutral Gear-Shift Position (page
43).
3. Verify that all of the positions are working
correctly by repeating the steps in
Neutral Gear-Shift Position (page
Maintaining the Primary
Drive Clutch
Service Interval: Every 400 hours/Yearly (whichever
comes first)
CAUTION
The dust in the clutch will become airborne
and could damage your eyes or you could
inhale it, causing breathing difficulties.
Wear safety goggles and a dust mask or
other eye and respiratory protection when
performing this procedure.
1. Remove the 3 bolts securing the cover to the
clutch, and remove the cover
Note:
Retain the cover and bolts for installation.
Figure 50
1. Cover
2. Thoroughly clean the inside of the cover and
the inner components of the clutch using
compressed air.
3. Install the clutch cover and secure it with the 3
bolts (Figure 50) that you removed in 1.
Checking the
43).
(Figure 50).
g011947
2. Bolts

Reducing the Top Speed

CAUTION
The dust in the clutch will become airborne
and could damage your eyes or you could
inhale it, causing breathing difficulties.
Wear safety goggles and a dust mask or
other eye and respiratory protection when
performing this procedure.
1. Remove the bolts securing the primary clutch
cover as shown in
Important:
Use caution when removing
the clutch cover; the spring is under
compression.
Important:
Take note of the X orientation
on the clutch covers and clutch assemblies
for later installation.
1. Clutch spacer
2. Remove the spring.
3. Add or remove spacers to adjust the top speed.
Use the following table to determine the amount
of spacers needed.
Spacers
2 (standard)
3
4
5
6
Important:
Do not operate the machine
without at least the thicker spacer in place.
4. Install the spring and clutch cover.
Important:
Ensure that the X is placed back
in the original location.
44
Figure 51.
Figure 51
Top Speed
16 mph (standard)
12 mph
9 mph
6 mph
4 mph
g026341