Route Wires And Attach Connectors; Make The Connections - Bosch AutoDome 700 Series Installation Manual

AutoDome 700 Series IP PTZ Camera
2.4

Route Wires and Attach Connectors

Power wires must be routed to the left (front) side of the Power Supply Box through a
separate conduit. All video, control, and alarm wires must be routed through a second conduit
to the right side of the box.
If you plan to route the power through an intermediate power supply box, refer to
Section 2.5 Route Power through Intermediate Power Supply Box, page 18.
WARNING!
External interconnecting cables are to be installed in accordance to NEC, ANSI/NFPA70 (for
US application) and Canadian Electrical Code, Part I, CSA C22.1 (for CAN application) and in
accordance to local country codes for all other countries.
Branch circuit protection incorporating a 20 A, 2-pole Listed Circuit Breaker or Branch Rated
Fuses are required as part of the building installation. A readily accessible 2-pole disconnect
device with a contact separation of at least 3 mm must be incorporated.
2.4.1

Make the Connections

Figure 2.2 Pendant Arm Power Supply Box
1.
2.
3.
4.
Bosch Security Systems, Inc.
P101
24V NC 24V
P106
GND T XD R XD C+ C- GND T XD R XD
Route all video, control, and alarm wires through the conduit fitting on the right side of
the power box. Refer to Section 5 Cable and Wire Standards, page 57, for wire
specifications and distances.
Route the high voltage 115/230 VAC lines through the conduit fitting on the left side of
the box. The Power Supply Box with a transformer comes with a barrier that separates
the high voltage side on the left, from the low voltage 24 VAC side on the right.
Cut and trim all wires with sufficient slack to reach their connector terminals in the box,
but not so long as to be pinched by or to obstruct closing the Pendant Arm. Refer to
Figure 2.2, Page 15, above, for the connector locations.
Attach the supplied 3-pin Power Plug to the incoming power wires. Refer to connector
P101 in Table 2.1, Page 18, for wire connections.
Installation Manual
Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts | en
J102
24 VAC
(LED)
P105
C+ C-
15
F.01U.215.779 | 1.0 | 2011.07