Table of Contents
Advertisement
AutoDome 700 Series IP PTZ Camera
2.4.2
Power Supply Box Connections
The following figure is a detailed illustration of the Pendant Arm Power Supply Box, which
includes the fuse specifications.
Figure 2.4 Pendant arm power supply box
1
2
3
4
4a UTP/ Ethernet
5
WARNING!
Fuse replacement by qualified service personnel only. Replace with same type fuse.
Volts
115 V
230 V
Bosch Security Systems, Inc.
TRANSFORMER
(115/230VAC
MODELS)
P101
24V
NC
24V
1 2 3
P106
GND TXD RXD
C+ C-
6 5 4 3 2 1
Ground Screw
From Harness
In/Out; 1/2 in. (15 mm) NPS Fitting 8
Video
(Ethernet for VG5 700 Series only)
24 VAC to Dome
Fuse Specifications
XF101 Mains
XF102 Camera
24 V
T 5.0 A
T 1.6 A
T 0.8A
Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts | en
J102
a
(LED)
P105
GND TXD RXD
C+ C-
6 5 4 3 2 1
6
In/Out; 1/2 in. (15 mm) NPS Fitting
7
P101 Connector; Power In
P106 Connector; Control In/Out
9
P105 Connector; Control to Dome
10 Power In; 3/4 in. (20 mm) NPS Fitting
11 Control Data and Video In/Out; 3/4 in. (20 mm)
NPS Fitting
XF103 Heater
T 2.0 A
T 3.15 A
T 2.0 A
T 3.15 A
T 2.0 A
T 3.15 A
Installation Manual
17
F.01U.215.779 | 1.0 | 2011.07
Advertisement
Table of Contents
