Make Connections In The Power Supply Box - Bosch AutoDome 700 Series Installation Manual

AutoDome 700 Series IP PTZ Camera
3.
4.
CAUTION!
If you feel any resistance when rotating the dome housing or when engaging the connector,
stop immediately and start over.
5.
CAUTION!
You must tighten the two mounting screws to a minimum torque of 10-12 N-m (90-105 in.-lbs)
to ensure a proper seal between the arm and the housing.
6.
7.
CAUTION!
Do not over tighten the bolts. The maximum torque is 34 N-m (25 ft-lb).
3.9

Make Connections in the Power Supply Box

The following procedure references Figure 3.6, Page 39 to locate the various connectors in the
box and to make the proper connections.
1.
2.
3.
Bosch Security Systems, Inc.
Drop the Pendant down slightly to engage the dome hook and hinge pin of the Dome
Cap, allowing the dome to rotate around the hinge pin.
Rotate the dome housing down to a vertical position and gently push upward to engage
the connector on top of the dome housing.
Hold the housing firmly in position and alternately tighten the two (2) 5-mm Allen head
mounting screws from above to a torque value of 10-12 N-m (90-105 in.-lbs).
Rotate the arm to swing the AutoDome out from the roof and into position, if installing a
Parapet Roof Mount.
Tighten the three (3) 10-mm (3/8-inch) stainless steel hex bolts on the bracket to lock
the Parapet Arm in position. Refer to Figure 3.13, Page 46, for an illustration.
Attach the earth ground wire to the grounding screw on the left side of the box.
Connect the 24 VAC to Dome plug, installed previously, to its mating connector P107 on
the right side of the box.
Connect the 115/230 VAC, 3-pin Power-in plug, installed previously, to its matting
connector P101 on the left side of the box.
Installation Manual
Installing the Roof Parapet and Pipe Mounts | en
F.01U.215.779 | 1.0 | 2011.07
47