Servicing The Engine Oil - Toro 22322 Operator's Manual

1. Hose clamp
2. Hose to carbon canister
3. Carbon canister
4. Install a new filter onto the carbon canister
5. Install the rear-access cover; see
Rear-Access Cover (page
Replacing the Carbon-Canister
Purge-line Filter
Service Interval: Every 200 hours—Replace the
carbon-canister purge-line filter
(Service more frequently when using the
vibratory plow attachment).
Note: Check the purge-line filter occasionally for dirt. If the
filter appears to be dirty, replace it.
1. Lower the loader arms, shut off the engine, and remove
the key.
2. Remove the rear-access cover; see
Rear-Access Cover (page
3. Move the spring-type hose clamps on both sides of the
carbon-canister purge-line filter away from the filter
(Figure 34).
4. Remove and discard the purge-line filter
5. Install a new filter into the hose with the arrow on
the filter pointing away from the carbon canister and
secure it with the hose clamps
6. Install the rear-access cover; see
Rear-Access Cover (page
1 2
4
5
6
Figure 34
4. Air filter
5. Purge-line filter
6. Rear access door
(Figure
Closing the
26).
Opening the
25).
(Figure
(Figure 34).
Closing the
26).

Servicing the Engine Oil

Service Interval: After the first 50 hours
Every 100 hours—Change the engine oil.
Every 200 hours—Change the oil filter.
Note: Change the oil and filter more frequently when
operating conditions are extremely dusty or sandy.
Oil Type: Detergent oil (API service SG, SH, SJ, or higher)
3
Crankcase Capacity: with filter, 2.0 L (2.1 US qt)
Viscosity: See table below
G018430
34).
Changing the Oil
1. Start the engine and let it run for 5 minutes. This
warms the oil so that it drains better.
2. Park the traction unit so that the drain side is slightly
lower than the opposite side to ensure that the oil
drains completely.
3. Lower the loader arms, set the parking brake, shut off
the engine, and remove the key.
CAUTION
Components will be hot if the traction unit has
34).
been running. If you touch hot components,
you may be burned.
Allow the traction unit to cool before
performing maintenance or touching
components under the hood.
4. Remove the drain plug
29
Figure 35
(Figure 36).
G005564